This set of IC Engines Multiple Choice Questions & Answers (MCQs) focuses on “Heat Rejection”.
1. The transfer of heat takes place due to difference in temperature and from higher temperature to lower temperature.
a) True
b) False
View Answer
Explanation: None.
2. The hot gases give part of their heat to ____________
a) cylinder liner
b) piston and piston rings
c) cylinder head
d) all of the mentioned
View Answer
Explanation: The hot gases give part of their heat to
i) cylinder liner
ii) piston and piston rings
iii) cylinder head
iv) exhaust valves and exhaust ports.
3. Most of the heat is carried away by the cooling system while some are lost by direct radiation from the engine surfaces.
a) True
b) False
View Answer
Explanation: None.
4. At the end of the induction stroke the temperature is that of clearance gases.
a) True
b) False
View Answer
Explanation: No, but in fact, at the beginning of induction stroke the temperature is that of clearance gases.
5. As the cool mixture is inducted into the engine cylinder the temperature rises rapidly.
a) True
b) False
View Answer
Explanation: Actually, as the cool mixture is inducted into the engine cylinder the temperature falls rapidly.
6. During compression process the temperature ____________ and attains its maximum value at the end of combustion process.
a) decreases
b) increases
c) remains same
d) none of the mentioned
View Answer
Explanation: During compression process the temperature increases and attains its maximum value at the end of combustion process while during the expansion process the temperature decreases and then drops very rapidly during the release process.
7. During the expansion process the temperature ____________ and then drops very rapidly during the release process.
a) decreases
b) increases
c) remains same
d) none of the mentioned
View Answer
Explanation: During the expansion process the temperature decreases and then drops very rapidly during the release process while during the compression process the temperature increases and attains its maximum value at the end of the combustion process.
8. Inadequate lubrication of the engine, due to oil not being warm enough to flow freely, results in greater frictional losses.
a) True
b) False
View Answer
Explanation: None.
9. A hot-spot outside the combustion chamber may be sufficient to cause pre-ignition.
a) True
b) False
View Answer
Explanation: In fact, a hot-spot inside the combustion chamber may be sufficient to cause pre-ignition.
10. If the engine is overcooled some of the heat which could be used to expand the gases will be lost.
a) True
b) False
View Answer
Explanation: None.
Sanfoundry Global Education & Learning Series – IC Engine.
To practice all areas of IC Engine, here is complete set of 1000+ Multiple Choice Questions and Answers.
If you find a mistake in question / option / answer, kindly take a screenshot and email to [email protected]
- Apply for Mechanical Engineering Internship
- Practice Mechanical Engineering MCQs
- Check Mechanical Engineering Books
- Check IC Engine Books
