This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Worm Gears”. 1. When bevel gears having equal teeth and equal pitch angles connect two shafts whose axes intersect at right angle, then they are known as a) angular bevel gears b) crown bevel gears c) internal bevel gears d) mitre gears … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Bevel Gears”. 1. The bevel gears are used to connect a) two parallel shafts b) two intersecting shafts c) two non intersecting shafts d) none of the mentioned 2. Bevel gears with shafts angle of 900 are termed as a) zerol gears … Read more
This set of Machine Kinematics Problems focuses on “Minimum Number of Teeth on a Pinion for Involute Rack in Order to Avoid Interference”. 1. The minimum number of teeth on the pinion which will mesh with any gear without interference for 200 full depth involute teeth will be a) 12 b) 14 c) 18 d) … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Standard Proportions of Gear Systems”. 1. If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, the formative number of teeth is written as a) T sec3 φ b) T sec2 … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Comparison Between Involute and Cycloidal Gears”. 1. The velocity of sliding _____________ the distance of the point of contact from the pitch point. a) is directly proportional to b) is inversaly proportional to c) is equal to cosɸ multiplied by d) does … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Spur Gears”. 1. The gears are termed as medium velocity gears, if their peripheral velocity is a) 1–3 m / s b) 3–15 m / s c) 15–30 m / s d) 30–50 m / s 2. The size of gear is … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Systems of Gear Teeth”. 1. The face of the tooth is the a) surface of the top of tooth b) surface of tooth above the pitch surface c) width of tooth below the pitch surface d) width of tooth measured along the … Read more
This set of Machine Kinematics Questions & Answers for Exams focuses on “The Differential & Torques in Epicyclic Gear Trains”. 1. To split the engine torque in two ways, which of the following device is used? a) Clutch b) Brake c) Final drive d) Differential 2. Two wheelers are also equipped with a differential. a) … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Types of Gear Trains”. 1. A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm … Read more
This set of Machine Kinematics Multiple Choice Questions & Answers (MCQs) focuses on “Gear Trains”. 1. In a simple gear train, if the number of idle gears is odd, then the motion of driven gear will a) be same as that of driving gear b) be opposite as that of driving gear c) depend upon … Read more
