This set of MSP430 Microcontroller Assessment Questions and Answers focuses on “Asynchronous Serial Communication”. 1. Asynchronous serial communication usually requires two wires for each direction plus a common ground. a) true b) false c) cant be said d) depends on the conditions 2. In an asynchronous mode of transmission, usually the data is sent along … Read more
This set of MSP430 Micro-controller Multiple Choice Questions & Answers (MCQs) focuses on “I2C”. 1. The I2C bus uses which of the following lines? a) CLK b) MISO c) SDA d) All of the mentioned 2. I2C is a faster means of data transfer than SPI? a) yes b) no c) depends on the conditions … Read more
This set of MSP430 Microcontroller Questions and Answers for Aptitude test focuses on “SPI”. 1. Is SPI a full duplex technique? a) yes b) no c) cant be said d) depends on the conditions 2. The concept of SPI is based on __________ a) two counters b) four flip flops c) two shift registers d) … Read more
This set of MSP430 Micro-controller Multiple Choice Questions & Answers (MCQs) focuses on “Communication”. 1. What actually is a bit bagging? a) it actually refers to the technique of assigning the bits with their inputs b) a technique by which an MSP430 can communicate through hardware c) a technique by which MSP430 can communicate through … Read more
This set of MSP430 Microcontroller Questions and Answers for Campus interviews focuses on “Sigma Delta ADC”. 1. The basic idea behind the sigma delta converter is that a) to carry out the conversion b) to carry out communication c) to reduce the circuit to its simplest way possible and then carry out the conversion d) … Read more
This set of MSP430 Microcontroller Questions and Answers for Entrance exams focuses on “Successive Approximation ADC”. 1. The successive approximation converters have a resolution of _________ a) 8-10 bits b) 10-12 bits c) 12-16 bits d) 16-32 bits 2. In SAR based conversions, each bit typically requires one clock cycle (sometimes two) to make a … Read more
This set of MSP430 Micro-controller Multiple Choice Questions & Answers (MCQs) focuses on “Comparator”. 1. Comparator_A+ is controlled by which of the following peripheral registers? a) CACTL1 b) CACTL2 c) CACTL1 & CACTL2 d) None of the mentioned 2. CAON bit is used to ___________ a) start a timer b) start an A/D conversion c) … Read more
This set of MSP430 Microcontroller Question Bank focuses on “Mixed-Signal Systems: Analog Input and Output”. 1. Which of the following is the analog to digital converter that is present in the MSP430 based processors? a) comparator b) successive approximation ADC c) sigma delta ADC d) all of the mentioned 2. Higher resolution along with the … Read more
This set of MSP430 Microcontroller online quiz focuses on “TIMER_B”. 1. Why Timer_B is not considered as most suitable one for receiving asynchronous signals? a) because of the absence of the TBOUTH input pin b) because of the presence of the TBOUTH input pin c) because of the absence of the SCCI bit d) because … Read more
This set of MSP430 Microcontroller online test focuses on “TIMER_A”. 1. All channels within Timer_A share the same timer block? a) yes b) no c) cant be said d) depends on the conditions 2. Timer_A has _________ a) RTC module in it b) Compare/ capture channel c) Communication channel d) Converter channel 3. TACLK and … Read more
