This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Idealized Structure”. 1. How many constraints are there in a fixed support? a) 2 b) 3 c) 6 d) Can’t say 2. How many constraints are there in a free-rotation support used in a planar system? a) 1 b) 2 c) 3 … Read more
This set of Structural Analysis Questions and Answers for Freshers focuses on “Equivalent Lateral Force Procedure for Estimating Seismic Loads-2”. 1. The below figure is an incomplete diagram of a hospital consisting of reinforced concrete frames with rigid joints. Given that SDS = 1.2g and SDI = 0.5 g and w= 400k. Find the fundamental … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Equivalent Lateral Force Procedure for Estimating Seismic Loads – 1”. 1. Seismic loads are directly proportional to the exposed area of the building. State whether the above statement is true or false. a) True b) False 2. Which types of forces are … Read more
This set of Structural Analysis Interview Questions and Answers focuses on “Types Of Structural Loads – 2”. 1. Find the value of reduction factor R2 if F (rise to span ratio in inches) is given to be 5. a) 0.95 b) 0.96 c) 0.97 d) 0.98 2. What will be the value of reduction factor … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Types Of Structural Loads – 1”. 1. Which of the following structural loads are not applied commonly to a building? a) Dead load b) Rain load c) Live load d) Environmental load 2. Dead load comprises of:- a) Permanently attached loads b) … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Loading Conditions for Strength Design”. 1. By Strength Desig method, the load factors are:- a) Smaller than 0.5 b) 0.5 < 0.75 c) 0.75 < 1 d) Larger than 1 2. Purpose of load factors is to account for:- a) Lapse in … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Loading Conditions for Allowable Stress Design”. 1. With the allowable stress method, which conditions are computed? a) Most severe loading conditions and inelastic stresses b) Most severe loading conditions and elastic stresses c) Feeble loading conditions and inelastic stresses d) Feeble loading … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Live Load Reduction”. 1. If influence area contributing to a particular load increases, then what happens to the possibility of having full design load on each square meter of area? a) Increases b) Decreases c) Doesn’t affect d) Depends on case 2. … Read more
This set of Structural Analysis Multiple Choice Questions & Answers (MCQs) focuses on “Tributary Areas”. 1. The tributary is an unloaded area. This statement is:- a) True b) False 2. The tributary area lines between two columns/beams are at how much distance from one of the beam? a) 0.2 of the total in between length … Read more
