This set of Automobile Engineering Multiple Choice Questions & Answers (MCQs) focuses on “IC Engine Crankshaft and Camshaft”.
1. In a four stroke cycle engine camshaft revolves at ______ the crank speed.
a) Two times
b) Half
c) Four times
d) Three times
View Answer
Explanation: The camshaft rotates at half of the crank speed.
2. The gears on camshaft and crankshaft are known as ________
a) Lining gears
b) Aligning gears
c) Timing gears
d) Tuning gears
View Answer
Explanation: These gears are called timing gears. Timing gears connect camshaft to the crankshaft. Timing gears provide 2:1 gear reduction for four stroke engines.
3. The material known as high carbon high copper chrome silicon cast steel is used for making _________
a) Camshaft
b) Cylinder body
c) Cylinder head
d) Piston
View Answer
Explanation: Material used for making camshafts is high carbon high copper chrome silicon cast steel.
4. Camshaft gear is made from which material?
a) Cast iron
b) Mild steel
c) Bakelite
d) Brass
View Answer
Explanation: Camshaft gears are made from bakelite.
5. Crankshafts are usually constructed by ______
a) Casting
b) Drop forging
c) Drawing
d) Extrusion
View Answer
Explanation: Drop forging is used for making crankshafts.
6. The main reasons for crankshaft wear are _______
a) Different loads at some points of rotation
b) Centrifugal forces due to crankshaft rotation
c) Misalignment in connecting rod
d) All of the mentioned
View Answer
Explanation: All the three are the reasons for crankshaft wear.
7. The main causes of crankshaft vibration are _________
a) Variation in torque
b) Cyclic variation of gas and combustion products
c) Unbalanced weight of parts
d) All of the mentioned
View Answer
Explanation: Crankshaft vibration is caused by all the above mentioned causes.
8. In the cam, the distance between the base circle and the nose is called ______
a) Lift
b) Lobe
c) Flank
d) Pitch
View Answer
Explanation: Distance between the base circle and nose is called lift of cam.
9. The crankshaft rotates the camshaft using _______
a) Belt drive
b) Chain drive
c) Gear drive
d) Motor drive
View Answer
Explanation: Chain drive is used to connect crankshaft and camshaft.
10. The crankshaft should be inspected for ______
a) Cracks
b) Alignment of crankpins and journals
c) Cleanliness of oil gallaries
d) All of the mentioned
View Answer
Explanation: Crankshaft should be inspected for all the above mentioned faults.
Sanfoundry Global Education & Learning Series – Automobile Engineering.
To practice all areas of Automobile Engineering, here is complete set of 1000+ Multiple Choice Questions and Answers.
- Practice Mechanical Engineering MCQs
- Apply for Mechanical Engineering Internship
- Check Mechanical Engineering Books
- Check Automobile Engineering Books